Rec-Tec has a strong following, and – as with the rest of the pellet grills in this review, will do you right. They’ve recently gone to an all black (no more red) look with their newer models. Though, you can probably still get the red. They have the most pellet holding capacity of any other grills pretty much, so that might be a plus for you. Getting temps back down is pretty fast… 5-10 minutes or so. I’d consider reverse searing, so long as your steaks are 1 and 1/2 inches or more. Thinner cuts won’t work. So, basically – you get the steak up to around 125-35 at around 225-250 F. Wrap it in foil. Then, crank your heat up to the highest setting, remove your steak from the foil, and sear it off on both sides to your desired doneness level. This limits the amount of grey – making for a more uniform pink from the top to the bottom of the steak.
With a temperature probe for the meat inside the chamber, this allows you to keep an eye on the temperature of your meat without opening the grill. Nothing ruins a brisket or roast faster than the griller who constantly fiddles with the meat on the grill. Opening the chamber lets the heat out and that can quickly make for some tough meat. This handy feature takes the guesswork out of how ready your meal is, helping you get the best outcome.
Maintenance is an issue. There are moving parts on these grills. Moving parts eventually break. There is an auger with a motor, and a fan with a motor. There are proprietary electronics systems on these babies. Augers clog. Motors burn out. Electronics have bugs or fail. Especially when exposed to rain, snow, hot, and cold. When they fail, will the manufacturer have a replacement part?
To sear a steak you need direct radiant heat. I don't care if you can heat the air to 1000°F, it is still indirect heat and that does not deliver as much energy as direct radiant heat. It's physics, but not hard to understand. In short, heat is not the same as temperature. It feels hotter at 80°F if the sun is shining on you than if it is 80°F in the shade. I discuss the concept in more detail in my article on thermodynamics of cooking.
Though the Memphis Pro works great as a high heat, sear, and direct flame grill, I chose to do some IBP ribs and a couple all natural pork loins I picked up from the store. I won’t go into too much detail on the pork loin and rib prep here, suffice it to say that I was very impressed with the smoke output I got from this unit, which I filled with a full compliment of Cookshack Fruitwood Pellets.
Pellet grills have a couple of very distinct advantages and disadvantages. The best can hold a constant temperature more or less indefinitely, provide even smoke at low temps, cook w/o smoke at high temps, make it possible to evenly cook several different meats and do a good job at two zone cooking. The Yoder excels at these. It is built like a tank, easy to use and I love it. One drawback for some pellet grills is the inability to reach high temps and sear. With the GrillGrates I have reached almost 600F and can sear with the best of them. Drawbacks. Well, it is a bit tricky to clean, but I guess I am keeping it cleaner than I did my previous grills!